Water Heater Repair & Installation in Park Ridge
No hot water, rusty water or a leaking tank — repaired, or replaced with a properly sized unit.
A water heater usually gives warning before it fails: longer recovery times, popping sounds from sediment, rusty hot water or moisture at the base. We diagnose the actual fault — thermocouple, gas valve, heating element, thermostat or tank failure — and tell you whether a repair is worth doing.
When replacement makes more sense, we size the new unit to the way your household actually uses hot water and install it with correct venting, drain pan, expansion control and shutoff.
What this service includes
- Diagnosis of no-hot-water and lukewarm-water complaints
- Thermocouple, gas valve, element and thermostat repairs
- Tank water heater replacement and removal of the old unit
- Tankless water heater installation and service
- Temperature and pressure relief valve replacement
- Sediment flushing and maintenance
Signs it is time to call
- Hot water runs out much faster than it used to
- Rusty or metallic-smelling hot water
- Rumbling or popping from the tank
- Water on the floor around the base of the heater
Questions we get asked
- Repair or replace?
- If the tank itself is leaking, replacement is the only real fix. If the tank is sound and the failure is a control or burner component, a repair is often the better value. We give you both numbers before work starts.
- Do you install tankless units?
- Yes. Tankless works well for some homes, but it depends on gas supply, venting and hot water demand. We will tell you plainly if a conventional tank is the better fit for your house.
Plumbing problem in Park Ridge? Make us your first call.
Tell us what is going on and we will give you a straight answer about what it takes to fix it.